After installing the video surveillance capture card , you need to install the driver to use it normally, so what to do if the driver is not installed, the following editor will introduce it to everyone!
Reasons why the video capture card cannot be installed on the software:
1. During the installation process of the video capture card, it is mainly installed under a folder on the C drive. Sometimes during the installation process, it is blocked by the firewall and related drivers are blocked, so if the installation fails, the reason is resolved. It may be necessary to turn off the firewall before installing.
2. The video capture card driver is divided into two installation methods, the first is to directly install the EXE file to install, or the other is to jump out of the DOS interface to install. The first is often relatively simple to install, and the second may sometimes Before the wall is installed, the operator closes the software, so this situation will also make the computer drive impossible, so be sure to pay attention during the installation.
3. Video capture card software is divided into installation board and copy. The installation version mainly runs the corresponding EXE file through the CD-ROM, while the copy version often needs to package the software as a whole and send it to a comparable hard disk partition for direct operation. If these two software installation methods are mixed, it is definitely not possible. Use as usual.
4. The video capture card is compatible with the motherboard. Some video capture cards may not be compatible with the AMD motherboard, so it will not be installed.
Solution for video surveillance capture card hardware installation